Page 1
Repair Manual ID-100 (Vertical ) May 1997 Americas Business Center Technical Services 201 Burlington Road Bedford MA 01730 TEL: 1.781.386.5309 FAX: 1.781.386.5988...
Page 2
VERTICAL ID-100 CAMERA Description The Vertical ID-100 System is basically a standard ID-100 camera with the Optical Assembly/Data Card Holder mounted in the vertical position (Refer to Figure 1). The data card is inserted from the top. This produces a vertical ID card with subject and data appearing one on top of the other instead of side-by- side.
Page 3
ID-100 Manual Addendum Vertical Card Guide (PN 70154V) New Molded Front Shroud (PN 70100V) Figure 2 The following Logic Board and Strobe Board connectors were modified because they were obstructed by the repositioned Optical Assembly/Data Card Holder: Logic Board (Refer to Figure 3) •...
Page 4
ID-100 Manual Addendum Logic Board (PN SA71400V) Modified Harness Connector (P5) Note: Harness plugs into side of connector instead of top Modified Subject/Data Harness Shutter Solenoid Connector (P1) Harness Logic/Subject/Data Harness DC to DC Harness (PN 70141V) (PN 70140V) Figure 3 Logic Board...
(PN 70144V) Figure 5 Camera Repair Refer to the ID-100 Repair Manual for all repairs. All parts are the same except for those noted in this addendum. Important Prior to modification of the Logic and Strobe boards, all obstructed connections were soldered.
ID-100 Manual Addendum Special Parts Parts Description Part Number Front Shroud 70100V Vertical Card Guide 70154 DC/DC Harness 70140 Logic/Subject/Data Harness 70141 Subject Strobe Board SA71000V Logic Board SA71400V...