Repair Manual
Disassembling the Shutter Linkage
Disassembly
1.
Remove the Shutter Assembly. (See "Removing the Shutter Assembly,"
page 54)
2.
Disengage the Release Lever Spring. (Refer to Figure 4-17 for all steps
below)
3.
Remove the e-ring and lift the Release Lever from its post.
4.
Remove the e-ring and small phillips tapping panhead screw, washer and
Wheel Spring from the Pressure Lever; lift the Pressure Lever from its
post.
5.
Remove the Release Lever Spring.
6.
Remove the e-ring from the post on the Wheel; lift the Wheel Spring from
the Wheel.
7.
Disengage the Button Spring from the Right Button and Left Button.
8.
Remove the e-ring from the Right Button and Left Button; lift both Buttons
from their posts.
9.
Remove the e-ring from the Wheel and lift the Wheel from its post.
61
ID-200 Camera