Related Manuals for Polaroid ID100
Summary of Contents for Polaroid ID100
- Page 1 ID 100...
-
Page 2: Table Of Contents
: Figure shows recommended distance from subject to cam- Note era lens. If your system has been modified for close-up pictures, the correct distance is 40 in (1.0 m). “Polaroid,” “Polacolor” and “Identifilm” are trademarks of Polaroid Corporation, Cambridge, MA 02139 U.S.A. PW-17133M-1 June, 1999... -
Page 3: Camera, Laminator, And Die Cutter Setup
Camera, Laminator, and Plug the laminator power cord into the camera base. Die Cutter Setup System must be grounded using a power cord with a three- pronged grounded plug (applies only in countries with grounded electrical supplies), which must be plugged into an appropriate outlet. -
Page 4: Install The Validation Plate
Install the Validation Plate Load the Film The validation plate determines the location of the portrait on the The ID-100 Systems use Polaroid instant color films, such as: ID card. The validation plate may include a validating signature Polacolor 100 ID UV film or seal for additional security. -
Page 5: About The Camera Controls
About the Camera Controls If the aiming light goes off before you have aimed the camera, press the shutter button lightly to turn it on again. The camera will not take a picture if the aim light goes out. The control panel on the ID-100 Systems has indicators, knobs, and a selector switch. -
Page 6: Cut The Print
Use with wet or dry pictures. Insert a wet picture into the pouch with the picture facing the side imprinted with the word Polaroid. Insert a dry picture facing the non-printed side. Polaroid-printed transparent front and opaque back Wet pictures only. -
Page 7: Change The Data Card And Picture Contrast
Clean the Developer Rollers Insert the carrier into the laminator. Dirt on the developer rollers can cause spots on pictures and jammed film. : Do not scrape the rollers with sharp objects or disas- Important HE AT OF F RU semble the rollers. -
Page 8: Adjust The Laminator Thermostat
Troubleshooting Insert the new batteries in the orientation (+/-) shown inside the compartment. No Leader Tab? Press the SET and START buttons simultaneously to make sure the timer is working properly. Open the film door without moving the film pack. Adjust the Laminator Thermostat Push the leader tab out. -
Page 9: Problem/Solution Table
Bedford, MA 01730. Outside the U.S.A., please contact the near- • Connect the equipment to an outlet on a circuit different est Polaroid Office (see back cover for a list of addresses and from the one to which the receiver is connected. phone numbers).