Advertisement
FALCON™ QUADROCOPTER DIAGRAM
Propeller Guard
Propeller Guard
Landing Gear
FALCON™ REMOTE DIAGRAM
Speed Setting
Throttle Lever
& Rotation Control
Up/Down Trim
Rotate Left/Right
Trim
Light
Orientation Mode
Power Switch
ATTACHING THE LANDING GEAR
• Attach the right and left landing gear legs on the underside of the
Falcon™ with the 4 screws provided (see diagram E) .
• Please note the right side landing gear has a notch to
accommodate the camera connection.
3
Propeller Blade
Li-Poly Battery Compartment
Antenna
Power Indicator
360º Flip Button
Direction Lever
Forward/Backward &
Bank Left/Right
Forward/Backward
Trim
Bank Right/Left
Trim
Photo
Channel &
Video
Power % Indicator
Notch
WARNING
DO NOT FLY YOUR FALCON™ IN FOUL WEATHER!
FLIGHT PREPARATION
• Verify that there are 6"AA"batteries inside the remote control unit and the Falcon™ has been
fully charged.
• Make sure your Falcon™ and controller are both turned on.
• Make sure to be in a large space with an open radius of at least 50 feet.
• Make sure the empty space has no obstacles.Set your Falcon™ on a clean flat surface before take-off.
DO NOT ATTEMPT TO FLY YOUR FALCON™ IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING
OUTDOORS. IT COULD DAMAGE YOUR PRODUCT AND POSSIBLY EVEN CAUSE BODILY HARM.
SYNCING YOUR FALCON™
Important! When syncing your Falcon™ quadrocopter with the controller always make sure that the
quadrocopter is on a flat level surface and that your digital trim settings are in the center position.
This insures that the 6 Axis gyro is properly programmed to mimic your trim settings.
Your Falcon™ utilizes an automatic 2.4G channel selection system that allows up to 8 people to fly side by
side in the same wireless range with no interference.
Syncing your aircraft:
1. Before starting,make sure that the power on your controller is in the OFF position and the Falcon™
wire leads are not connected.Make sure that there are no other 2.4G devices in the area as well .
2. Connect the battery wire lead to the Falcon™ lead and replace Battery cover (see diagram C) and turn
the Falcon over and set it down on a flat surface (see diagram F).The LED indicator lights of the Falcon™
will begin to flash.
3. Turn ON the remote,the flashing LED lights should change to solid,and you should hear 2 beeps push
the throttle on the left all the way forward and then slowly pull the throttle all the way back until you hear
a beep.Your controller and the Falcon™ should now be successfully synced ,if not,repeat above steps.
F
FLYING TIPS
• It is recommended that you operate the Falcon™ in a wide space.The ideal space should have a
200 foot radius.
• Parental guidance or adult supervision is suggested at all times.
• If you are flying the Falcon™ with others,make sure all spectators are behind you.
• For best performance,it is recommended that you operate the Falcon™ in zero wind conditions.
Heavy wind can greatly affect the performance of the aircraft or cause injury.
4
Advertisement
