Propel RC FALCON Instruction Booklet
Propel RC FALCON Instruction Booklet

Propel RC FALCON Instruction Booklet

Full sized high performance camera drone

Advertisement

Quick Links

CARE AND MAINTENANCE
• Always remove the batteries from the wireless remote control when it is not being used for an
extended period of time.
• To clean,gently wipe the remote control and Falcon™ with a clean damp cloth.
• Keep the toy away from direct heat or sunlight.
• Do not submerge the toy into water.This can damage the unit beyond repair.
• Parental guidance recommended when installing or replacing the batteries.
FCC Part 15 B Notice
CAUTION:Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment generates,uses and can radiate radio
frequency energy and,if not installed and used in accordance with the instructions,may cause harmful
interference to radio communications.However,there is no guarantee that interference will not occur in a
particular installation.If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions :
(1) This device may not cause harmful interference,and
(2) this device must accept any interference received,including interference that may cause undesired
operation.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:(1) this
device may not cause interference,and (2) this device must accept any interference,including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation est
autorisée aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage,et (2) l'utilisateur de l'appareil doit accepter
dout brouillage radioélectrique subi,même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of ASTM, CPSIA and FCC.
©2015 Rooftop Brands™ All rights reserved
Tel:+ (1) 949-566-9573 • www.propelrc.com
FALCON
Full Sized High Performance Camera Drone
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect the Falcon™ from charger immediately after the
Falcon™ is fully charged. Please refer to enclosed safety instructions.
Falcon
Drone
2.4G Wireless Controller
Made in China
INSTRUCTION BOOKLET
PACKAGE CONTAINS:
Battery Charger
Spare Parts
USB Card Reader
Colors and styles may slightly vary.
Instruction Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FALCON and is the answer not in the manual?

Questions and answers

Summary of Contents for Propel RC FALCON

  • Page 1 • Always remove the batteries from the wireless remote control when it is not being used for an extended period of time. • To clean,gently wipe the remote control and Falcon™ with a clean damp cloth. Full Sized High Performance Camera Drone •...
  • Page 2: Table Of Contents

    Flying Tips ............. 4 Recognizing The Front & Back Of The Falcon™....... 5 4 Channel Flight Control.
  • Page 3: Falcon™ Quadrocopter Diagram

    2. Connect the battery wire lead to the Falcon™ lead and replace Battery cover (see diagram C) and turn 360º Flip Button the Falcon over and set it down on a flat surface (see diagram F).The LED indicator lights of the Falcon™ will begin to flash.
  • Page 4: Recognizing The Front & Back Of The Falcon

    Below is a list of basic flight functions for your long-range remote control Falcon™.While learning to fly the problem is resolved. your Falcon™ it is best to start with a large space until you get used to the basic controls.As you master flying your Falcon™ you can move to more advanced maneuvering techniques.Practice makes perfect! Spin Right/Left Trim When you have these basic steps down you can move to the next level.
  • Page 5: Flight Practice

    2.Aircraft not fully charged 2.Recharge your Falcon™ PERFORMING 360º STUNT FLIPS Aircraft After you have mastered flying the Falcon™ you are ready to try flips.Once the Falcon™ is hovering at least Descends 1.Moving the throttle too quickly 1.Control the throttle slower and 3 meters (about 10 feet) off the ground click the 360º...
  • Page 6: Operating The Camera

    BATTERY WARNINGS Always disconnect the battery before replacing the propeller blades. Please note that the blades and the Falcon™ are labeled with an embossed A or B (see diagram P ). RECHARGEABLE BATTERY: This Falcon™ uses a Li-Poly rechargeable battery. If battery no longer stays charged,dispose of battery 2.

Table of Contents