FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
*This device complies with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. The device should be installed and operated with a
minimum distance of 20cm between the radiator and your body. This device must
not be collocated or operating in conjunction with any other antenna or transmitter.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter dout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING!
AVERTISSEMENT:
¡ADVERTENCIA!
CHOKING HAZARD- Small parts.
Not suitable for children under 3 years.
CHOKING HAZARD - Pièces de petite. taille N'est
Requires Class 6 or higher microSDHC card
pas conçu pour des enfants de moins de 3 ans.
(not included)
PELIGRO DE ASFIXIA- Partes pequeñas. No apto
para niños menores de 3 años.
microSDHC Logo is a trademark of SD-3C, LLC.
Conforms to safety requirements of FCC.
PROPEL RC™ and SKY MASTER™ are trademarks of Rooftop Brands.
8619 Wall street, Suite 400, Austin, TX 78754 tel: 949.566.9573
© 2016 Rooftop Brands™. All Rights Reserved. www.propelrc.com.
15
SKY MASTER
2.4GHz Quadrocopter With HD Camera
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect Sky Master
Sky Master
Made in China
CAN ICES-3(B)/NMB-3(B)
INSTRUCTION BOOKLET
battery from charger immediately after
TM
it is fully charged. Please refer to enclosed safety instructions.
PACKAGE CONTAINS:
ON
TM
2.4G Wireless
Spare Parts
AC Charger
Phone Holder
Controller
& Li-Poly
Rechargeable Battery
Colors and styles may slightly vary.
+ FPV
TM
ON BOARD
ON BOARD
HD CAMERA
HD VIDEO
1280 x 720 pixel
30 frames per second
USB Card
Instruction
Manual
Reader
BC
PROPEL
Need help?
Do you have a question about the sky master+fpv and is the answer not in the manual?
Questions and answers
How to connect bluetooth to my phone tablet? What button do u push to send the pairing signal
The Propel Sky Master FPV connects to a phone or tablet using Wi-Fi, not Bluetooth. To connect:
1. Go to the Settings menu on your mobile device.
2. Turn ON the Wi-Fi option.
3. Select “Propel Sky Master” from the Wi-Fi list.
4. Wait for the Sky Master to connect.
There is no mention of a Bluetooth connection or a button to send a pairing signal.
This answer is automatically generated