Advertisement
FCC PART 15 C NOTICE
CAUTION: Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter dout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
Conforms to safety requirements of ASTM, CPSIA and FCC.
©2016 Rooftop Brands™ All rights reserved
Tel: + (1) 949-566-9573 • www.propelrc.com
Made in China
BATMAN and all related characters and elements © & ™ DC Comics.
WB SHIELD: TM & © WBEI. (s16)
Product may vary slightly from image.
INSTRUCTION BOOKLET
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect battery from charger immediately after it is fully charged.
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
BATWING
V1.0
TM
Please refer to enclosed safety instructions.
PACKAGE CONTAINS:
TM
2.4G Wireless Controller
USB Charging Cord
Charger
Spare Parts
Instruction Booklet
Colors and styles may slightly vary.
Advertisement
Summary of Contents for Propel RC BATWING
- Page 1 ©2016 Rooftop Brands™ All rights reserved WARNING! Tel: + (1) 949-566-9573 • www.propelrc.com CHOKING HAZARD - Small parts. Not suitable for children under 3 years. Made in China BATWING 2.4G Wireless Controller USB Charging Cord Charger Spare Parts Instruction Booklet BATMAN and all related characters and elements ©...
-
Page 2: Table Of Contents
TABLE OF CONTENTS FEATURES • Built in 6 axis gyroscopic chip keeps the BATWING™ extremely stable in all conditions. • Unique switch blade technology allows for 3ch and 4ch flight modes. Features • 3 different speed settings for slow to high speed flying. -
Page 3: Batwing™ Quadrocopter Diagram
• Make sure to be in a large space with an open radius of at least 50 feet. Propeller Blade • Make sure the empty space has no obstacles or bodies of water. Set your BATWING™ on a clean flat surface before take-off. -
Page 4: Recognizing The Front And Back Of The Batwing
Trim Controls trim button trim button • To start the batwing ™ for the first time , make sure the propeller guard is installed, and the speed is set to mode 1 (slow). BANKING LEFT/RIGHT TRIM • Make sure you have properly synced the batwing ™ As shown on page 4. -
Page 5: Channel Flight Control
Below is a list of basic flight functions for your long-range remote control BATWING™. While learning to fly your BATWING™ it is best to start with control BATWING™. While learning to fly your BATWING™ it is best to start with a large space until you get used to the basic controls. -
Page 6: Replacing The Propeller Blades
Stand away from the 1. In order to make your BATWING™ do 360º rolls you must fully charge your BATWING™ to reduce the risk of getting into the flight path. Warn spectators that you will battery.