Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Propel RC Manuals
  4. Drones
  5. Navigator
  6. Instruction booklet

Propel RC Navigator Instruction Booklet

High performance stunt drone
Hide thumbs

Advertisement

Quick Links

FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
connected.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
This product is manufactured by AMAX Group
12645 Memorial Drive Suite F1 #388 Houston, TX 77024
Propel™ and Propel RC™ are the licensed trademarks of Rooftop Group LTD Singapore.
©2018 All rights reserved. Visit us at www.propelrc.com
NAVIGATOR™ is the property of Eastern Design Group, USA.
©2017 All rights reserved.
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of FCC.
14
HIGH PERFORMANCE STUNT DRONE
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect STUNT DRONE from charger immediately after the
STUNT DRONE is fully charged. Please refer to enclosed safety instructions.
HIGH PERFORMANCE STUNT DRONE
Made in China
V 1.0
US
INSTRUCTION BOOKLET
PACKAGE CONTAINS:
2.4G Wireless Controller
Spare Parts
Colors and styles may vary slightly.
Instruction Booklet

Advertisement

loading

Related Manuals for Propel RC Navigator

Summary of Contents for Propel RC Navigator

  • Page 1 This product is manufactured by AMAX Group 12645 Memorial Drive Suite F1 #388 Houston, TX 77024 Propel™ and Propel RC™ are the licensed trademarks of Rooftop Group LTD Singapore. ©2018 All rights reserved. Visit us at www.propelrc.com NAVIGATOR™ is the property of Eastern Design Group, USA.

  • Page 2: Table Of Contents

    FEATURES TABLE OF CONTENTS Features ......................2 Remote Battery Installation .

  • Page 3: Syncing Your Stunt Drone

    WARNING STUNT DRONE DIAGRAM DO NOT FLY YOUR DRONE IN FOUL WEATHER! Safety Guard Rotor Blade SYNCING YOUR Stunt Drone Important! When syncing your Stunt Drone quadrocopter with the controller always make sure that the quadrocopter is on a flat level surface and that your digital trim settings are in the center position.

  • Page 4: Recognizing The Front And Rear Of The

    RECOGNIZING THE FRONT AND REAR OF THE QUADROCOPTER NOTE: The use of the Trim buttons are accompanied with a Beep tone. A single long Beep indicates the product is center trimmed. No beeps after press indicates the product is trimmed to the maximum on a Front "forward"...

  • Page 5: Channel Flight Control

    To change back to 4 Channel mode: 3 CHANNEL FLIGHT CONTROL PRESS the Direction Control stick vertically down then release again, you will hear 4 short beeps indicating the Stunt Drone is now set to 4CH mode. fly your Stunt Drone it is best to start with a large space until you get used to the basic controls. As you master flying your Stunt Drone you can move to more advanced maneuvering techniques.

  • Page 6: Calibrating The Stunt Drone

    CALIBRATING THE STUNT DRONE REPLACING THE PROPELLER BLADE 1. Place the Stunt Drone on a flat level surface. Your Stunt Drone propeller system is a precision instrument that may need repair or replacement from 2. Make sure the Stunt Drone is on and that the controller is synced (refer to syncing pg 4).
  • Page 7 STUNT DRONE WARNING: The Stunt Drone is designed for INDOOR or OUTDOOR. The Stunt Drone blades revolve at high speeds and can cause damage to the user, spectators and animals. Stand away from the Stunt Drone to reduce the risk of getting into the flight path.