Installation - CompuSTAR 2WSSR Installation And User Manual

Most likely, you did not push Button II for the required 2 seconds. Pushing Button II for
only a ½ second engages the optional auxiliary function instead of auto-start.
Another reason maybe that you are in Valet Mode. If there is a ZZZ icon on your remote-
pager unit, you are in this mode and all the functions of the CompuStar 2WSSR are disabled
except for keyless entry. Press Button (I+III) simultaneously for a ½ second to deactivate
Valet Mode.
If there is a problem in auto-starting your car, you will hear three chirps from your remote-
pager when you attempt to auto-start the vehicle. After waiting two seconds, the diagnosis
for the auto-start error will be indicated depending on the number of times the car chirps and
parking lights flash. For example, 4 car chirps and parking light flashes indicates that the car
did not auto-start because the trunk was open. Please see page 10 of the user's manual for
the error diagnosis table.
On a small minority of cars, you maybe equipped with a Valet Switch that is located under
the car's dashboard that disables the auto-start system manually when the switch is turned to
the on position. Turn the Valet Switch to the off position and your car will auto-start.
I N S T A L LA T I ON
Please refer the wiring diagram.
1. Dip Switch and Jumper Settings
Dip Jumper
Switch
Off Cut:
Automatic
Transmission
On Uncut:
Manual
Transmission
2 . T r a n s m i t t e r / R ec e i v e r L e a r n R o u t i n e
Your remote-pager has been programmed for your
specific CompuStar brain at the time of installation.
#1
Alternator
Sensing
Tach
Sensing
© 2001 Firstech, Inc. Page 12
#2
15 min run time
(25 min diesel)
25 min run time
(45 min diesel)