Safety Instructions; Electrical Connection - Zanussi ZFC627WAP User Manual

Hide thumbs Also See for ZFC627WAP:
Table of Contents


Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.


WARNING! Only a qualified person
must install this appliance.
Remove all the packaging and the transit bolts.
Do not install or use a damaged appliance.
Follow the installation instruction supplied with
the appliance.
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
Make sure the air can circulate around the
At first installation or after reversing the door
wait at least 4 hours before connecting the
appliance to the power supply. This is to allow
the oil to flow back in the compressor.
Before carrying out any operations on the
appliance (e.g. reversing the door), remove the
plug from the power socket.
Do not install the appliance close to radiators or
cookers, ovens or hobs.
Do not install the appliance where there is direct
Do not install this appliance in areas that are too
humid or too cold, such as the construction
appendices, garages or wine cellars.
When you move the appliance, lift it by the front
edge to avoid scratching the floor.


WARNING! Risk of fire and electrical
The appliance must be earthed.
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
Always use a correctly installed shockproof
Do not use multi-plug adapters and extension
Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Authorised Service
Centre or an electrician to change the electrical
The mains cable must stay below the level of the
mains plug.
Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
WARNING! Risk of injury, burns,
electrical shock or fire.
Do not change the specification of this
Do not put electrical appliances (e.g. ice cream
makers) in the appliance unless they are stated
applicable by the manufacturer.
Be careful not to cause damage to the
refrigerant circuit. It contains isobutane (R600a),
a natural gas with a high level of environmental
compatibility. This gas is flammable.
If damage occurs to the refrigerant circuit, make
sure that there are no flames and sources of
ignition in the room. Ventilate the room.
Do not let hot items to touch the plastic parts of
the appliance.
Do not put soft drinks in the freezer
compartment. This will create pressure on the
drink container.


Table of Contents

Table of Contents