Intel FALCON 8+ Quick Start Manual page 15

To access the camera options, navigate to 'Camera Option' on the Status Display:
Record/Stop
Dial 2
Review
Adjust Horizon
Roll Comp. ON/OFF
Inspection Payload ZS50*
Important settings on both cameras can be controlled via the Intel Cockpit Controller:
B2 Position
1 (LED off)
2 (LED on/Blue)
To access the camera options, navigate to 'Camera Option' on the Status Display:
Switch Camera
Adjust Horizon
Roll Comp. ON/OFF
Shooting parameters need to be set directly on the camera before take-off.
Additional cameras may be available. Please refer to the main manual
oPERATInG ThE UAS
UAS and Safety Check
The UAS and safety check must be performed once a day before the first flight, and any time it may be necessary (e.g. after
an incident like a hard landing). If you notice anything unusual, please contact support through your dealer, if you purchased
through a dealer; or support at Intel, if you purchased directly from Intel. You must follow these steps to complete a close UAS
and safety check:
1 Is the transport case free of
visible damage?
2 Is the UAS free of visible
damage?
3 Are all the propellers in good
condition?
Starts and stops a video recording
See previous table for details
Reviews images stored on the SD card
Adjusts the horizon (roll angle) while flying
Sets the gimbal to stop compensating roll movements
Activated Camera
Panasonic* RGB Zoom In/Out
Camera
FLIR Up - Trigger flat field correction
Down - Cycle through color
palette
Switches the live image preview between the two cameras
Adjusts the horizon (roll angle) while flying
Sets the gimbal to stop compensating roll movements
If there is new visible damage from the last transport, take special care
during the check of the complete UAS.
If there is visible damage, contact your supplier.
Replace propellers if there are any nicks, cracks, breaks or other damage.
R2 Function
(http://intel.com/Falconmanual)
Please note that shooting
parameters like shutter speed,
aperture and ISO need to be set
directly on the camera before
take-off.
Please note that preview
parameters like isotherms
and ACG need to be set via
configuration file on the FLIR SD
card before take-off.
if your camera is not described here.
QUICK START GUIDE – Rev. 06 July 2017
15