Porter-Cable PCXB115MS Instruction Manual page 28

7-5/16 in.
BASIC SAW OPERATIONS
WARNING
!
TURNING THE SAW ON (FIG. EE)
trigger switch (1). With the safety lock (2)
the miter saw ON.
NOTE:
To make the ON/OFF switch childproof.
Insert a padlock (not provided), or chain
with padlock, through the hole (3) in the
trigger switch. Locking the tool's switch,
users from turning the machine on.
blade brake. When the trigger switch is
released, the blade brake will stop the
blade within approximately 10 seconds.
1
1
7-5/16 in.
2
3
28
BEFORE LEAVING THE SAW
Never leave tool running unattended.
Turn power OFF. Wait for all moving parts
to stop.
Make workshop childproof. Lock the shop.
Disconnect master switches. Store tool
users.
WARNING
!
MITER CUT (FIG. FF, GG)
miter table by turning the miter handle (1)
counterclockwise.
2. While holding the miter handle, lift up on
the positive stop locking lever (2).
3. Rotate the miter table to the right or left
with the miter handle.
4. When the table is in the desired position,
as shown on the miter scale (3), release
the positive stop locking lever and tighten
the miter handle. The table is now locked
at the desired angle. Positive stops are
provided at 0°, 15°, 22.5°, 31.6°, 45° right
& left, and 55° right.
IMPORTANT: Always tighten the miter
handle (1) before performing every cutting
operation.
5. Turn the laser guide on and position the
workpiece on the table for pre-alignment
of your cut.
WARNING
!