Porter-Cable PCXB115MS Instruction Manual page 18

NOTE: If a miter saw stand is used, please
follow all instructions shown in that product's
instructions for proper mounting.
1. Fold the miter saw. (See the section of
"FOLDING THE CUTTING HEAD FOR
TRANSPORTATION AND STORAGE" on
page 16.)
surface or ground as shown in Fig. L.
3. Align the feet (2) of the base with the
grooves (3) of the support base (1) and
then insert the folded saw into the support
base (1), so that the miter saw could
stand on the ground.
WARNING
!
2
REAR
3/4 in.
plywood
TRANSPORTING THE SAW (FIG. M)
NOTE: To avoid damage, never carry the
miter saw by the switch handle. To reduce
the risk of serious personal injury, ALWAYS
secure all clamps, knobs, latches and locks
before lifting the saw.
1. Never carry the saw by the switch handle,
2. ALWAYS use the support base when
REAR
3
2
1
1
FRONT
18
View from rear of machine
WARNING
!
miter clamp or cutting head. The carry
handle is appropriate for when the saw is
folded only. When saw is not folded, the
hand holds should be used.
storing the saw vertically.
Carrying handle
4