Assembly And Adjustments - Porter-Cable PCXB115MS Instruction Manual

ASSEMBLY AND ADJUSTMENTS

WARNING
!
source
ASSEMBLY INSTRUCTIONS TO RAISE THE CUTTER HEAD (FIG. A, B, C, D, E, F)
WARNING
!
#8
Hold-down latch
#2
Bevel lock
handle
PLACE THE SAW ON A FLAT, STABLE SURFACE.
STEP 1: Thread the miter handle (1) into the hole located at the front of the table as shown in
STEP 2: Loosen the bevel lock handle (2) located behind the base as shown in
STEP 3: Pull out the safety lock pin (3) located next to the bevel lock handle as shown in
STEP 4: Lift the cutting head by the switch handle (4)
up just pass the 90° bevel setting.
STEP 5: Rotate the metal detent block (5), located on the right side behind the table
STEP 6: Tilt the cutting head back to 90° and then tighten the bevel lock handle (2). The
positive stop bolt (7)
STEP 7: Loosen the miter handle (1), grasp it and lift up the positive stop locking lever (6)
miter scale. Retighten the miter handle (1).
STEP 8: Slightly push down the cutting head using the switch handle (4) and pull out the hold-
down latch (8)
cutting head.
1
6
Cutting head
#4
Switch handle
#1
Miter handle
, counterclockwise 180°.
will now rest on the detent block (5).
located under the miter handle, to turn the table to 0° as shown on the
located near the back on the left side of saw. This releases the
3
2
15
#6
Positive stop
locking lever
to raise the cutting head straight
7
5
#7
#3
Positive
Safety
stop bolt
lock pin
#5
Detent block
Carrying handle
8