Dual Stage Shock Sensor; Auto-Start Function; Panic Mode - CompuSTAR 2WSSR User Manual

In alarm mode, the starter kill function ( this maybe an optional feature provided by
your installer) is activated. This feature disengages the starter mechanism on your car
that prevents you from starting your car even with a manual key when your vehicle s
alarm mode is activated.
Note :
(Siren duration is 30 to 60 sec depending on the options set at the time
of initial installation.)

Dual Stage Shock Sensor

The dual stage shock sensor on the CompuStar 2WSSR can detect between light and
heavy impact to your vehicle by sensing vibration produced by differing impacts.
Press Buttons (I+III) for 2 seconds to activate or deactivate the dual stage shock sensor.
A red-bordered indicator box labeled Shock will darken in the top left-hand corner of your
CompuGLO LCD showing that your dual stage shock sensor is activated.
The dual stage shock sensor will activate 30 seconds after the CompuStar alarm mode
is armed. When the dual shock sensor is engaged, the remote-pager security alerts will
be triggered by the following :
Light impact to your vehicle will activate the first stage shock sensor and the car
siren will chirp 4 times in addition to the parking lights flashing 4 times.
The remote pager unit will beep and a vibration icon will blink in the CompuGLO LCD.
Heavy impact to your vehicle will activate the second stage shock sensor and the car
siren will chirp for 30 to 60 seconds and the parking lights will flash for 30 to 60 seconds.
The remote-pager will be notified audibly and a hammer icon will blink in the Compu
GLO LCD. Press Button I for a second to turn off the second stage shock sensor
sirens and flashing lights.
Note :
You may want to deactivate the dual-stage shock sensor if you park your
vehicle where there is significant vibration.
Page 12

Auto-Start Function

Press Button II for 2 seconds to auto-start an automatic transmission engine.
You will hear one beep from your remote-pager if there is successful communication
with your vehicle. The engine will start and give you a visual confirmation by an exhaust
fume icon coming out from the tailpipe on the remote-pager CompuGLO LCD.
Remember that a manual key in the ignition is required to drive the car. In addition, the
anti-grind circuit (this maybe an optional feature provided by your installer) prevents
you from re-cranking the starter on a remote-started vehicle. Press Button II for 2
seconds in order to turn off an auto-started car. For manual transmission vehicles,
please use reservation mode.
The engine will run 15 or 25 minutes (25 or 40 min for diesel) depending on preset
options at the time of installation, and then shut off. If your remote-pager has a problem
starting the vehicle, the CompuStar controller will try 2 additional times. If the engine
does not start after the third attempt, please call your authorized CompuStar dealer.
Diagnosing problems with Auto-Start
If there is a problem in auto-starting your car, you will hear three chirps when you attempt
to auto-start the car. Wait for 2 seconds and the cause for the error will be indicated by
the number of times the car chirps and parking lights flash.
Error Number (# of times the
car chirps& parking lights flash)
1
2
3
4
5
6
7 Reservation Off (Manual Transmission Only)

Panic Mode

Panic Mode allows the owner to draw attention to the car in case of an emergency or in
order to easily locate your vehicle in a large parking lot. Press Button
on the remote-pager to enter Panic Mode. In this mode, the car will arm if not armed
already and the siren will activate and the parking lights will flash. In order to disengage
Panic Mode, press Button for 2 seconds. Then, press Button
IV
unlock/ disarm your vehicle.
Page 13
Error Reason
Engine On
Key On
Door Open
Trunk Open
Brake On
Hood Open
for 2 seconds
IV
for a second to
I