Troubleshooting - Aquacal DIG-220 Owner's Manual

Issue / Message Displayed
10) CHECK SYSTEM
Light
Flashing.
Message Displayed
"PURIFIER OFF - Add
Salt xxx lbs (No purifier
generation during this
display)
11) CHECK SYSTEM
Light Flashing.
Message Displayed
"Warning! Add Salt XXX
lbs (kg)"
12) CHECK SYSTEM
Light Flashing.
Message Displayed
"Freeze Protect"
13) CHECK SYSTEM
Light Flashing.
Message Displayed
"DEMO" instead of "On" or
"Off"
14) A small dot
"walks"
across the display.
15) CHECK SYSTEM
Light Flashing.
Message Displayed
"Pwr Ctrl Error"
16) CHECK SYSTEM
Light Flashing.
Message Displayed
"Control Error"
(No purifier generation
during this display)
32

TROUBLESHOOTING

P r o b l e m
Salt level extremely low (below 1900 ppm (2.0 g/l)
Salt level Low (below 2500 ppm
(2,5 g/l)).
Pump runs when no program is on.
Chlorine is not generated.
Display is inactive, but all functions such as purifier
are still operational.
Typical Solution
Same as LOW SALT message below.
Add the amount of salt shown on the display. Test the salt level with a
reliable salt test kit and compare to the DIG-220 display.
Calibrate if needed, see page-22.
Freeze protect function is active. See page-30 for description.
Disable demo mode, see page-23.
Pressing a key will activate the display .
Contact the factory for Warranty Status Procedures.
Contact the factory for Warranty Status/Procedures.