Philips VARI-LITE VL6000 Beam Luminaire User Manual page 93

Step 3. At rotating gobo wheel, slowly rotate wheel by hand until gobo to be removed is visible on
assembly.
Step 4. Carefully remove spring. Use pliers to help lift spring if necessary. Remove gobo glass.
Front of Assembly Shown
(side towards front lens)
Note:
Assembly shown for clarity.
Step 5. To install new gobo:
a. Align flat of glass to flat in carrier.
b. Replace spring. Ends of spring should be on carrier flat. Confirm that all corners of
02.97 08.000 2
CAUTION:
Figure A-5: Rotating Gobo Wheel - Gobo Installation
spring are secured in groove.
2 7 Ap ril 2 017
T
ROUBLESHOOTING AND
Do not touch glass with bare fingers.
Handle by gobo carrier only.
A
M
AINTENANCE
Open Position
(no gobo)
Rotating Gobo
Wheel Assembly
Gobo Glass
Spring
75