Troubleshooting Guide - SoundLogic BITS-1/5616 Instruction Manual

TROUBLESHOOTING GUIDE

Check the follows before requesting service
SYMPTOM
No power
No Sound
Sound distortion
No video output
Remote not
functioning
Radio reception
weak
B T ( B l u e t o o t h )
not functioning
AUX1
not functional
10
SBI-9015说明书JLE-12239 10
POSSIBLE CAUSE
AC Plug not plugged into
wall outlet
POWER Switch in OFF
position
The unit in standby mode
(STANDBY lndicator is light)
Volume in minimum position
The connected device is not
in payback mode
Sound output of the device
weak
Input source incorrect
Volume level too high
Bass level too high
Volume level of the connected
device too high
EQ of the connected device
was set to super bass or
others mode
The connected iPod/iPhone
is not set to TV Out mode
The batteries in the remote
control are consume
This unit have not paired to
the external BT device.
The audio connection cable
was inserted into the AUX 2
jack, the unit was turned to
AUX 2 mode.
POSSIBLE SOULTION
plug it to the wall outlet properly
Press the POWER Switch on the rear of
unit to ON position
Press the STANDBY Button on the unit or
Remote Control to turm on the unit from
standby mode.The STANDBY lndicator will
turm off and the Display will turn ON.
Rise volume level by pressthe VOL
(Volume)+Button
Plays the music/movie in the connected
device
Rise volume level of the connected device
Set the input source to AUX 1, AUX 2, iPod
/iPone/iPad or Radio as the connecting
Reduce the volume level by press
the VOL(Volume)- Button
Reduce the bass level by press the
BASS-Button
Reduce the volume level of the connected
device
Set the EQ the connected device to
normal
Set the connected iPod/iPone/iPad to TV
OUT Mode (For details,please refer to the
iPod/iPone/iPad User' s Manual)
Point the remote control to remote the
sensor on the unit within 16 feet, +/-30
degree
Replace by new batteries
Extend the FM antenna wire on the rear
of the unit and relocation it to get better
reception.
Pairing this unit to the external BT device
as it's user's Manuel.
Disconnect the audio connection cable
from the AUX 2 Jack. The unit will turn
back to AUX 1 mode.
2012-7-16 17:48:06