Specific Safety Instructions - Stanley PW6768 Instruction Manual

6.5hp 2800psi pressure washer
Table of Contents

Advertisement

SPECIFIC SAFETY INSTRUCTIONS

Warning! Do not use the pressure washer in areas where
there is a risk of explosion or fire from combustible materials.
The sparks possibly caused when using this pressure washer
may ignite combustible materials as well as flammable liquids,
paint, varnish, petrol, flammable gases and dust of an explosive
nature. As a precaution it is recommended that you consult an
expert on a suitable fire extinguisher and its use. Ensure that the
work area is kept clear of combustible materials.
Warning! Do not use the pressure washer indoors or in
confined spaces where exhaust gases, smoke or fumes could
reach dangerous concentrations.
Always use the pressure washer in an open well
ventilated area.
Ensure pressure washer is fully assembled before use.
Unit will become hot during use. Please keep pressure
washer at least one metre (1m) away from buildings, other
equipment, pedestrian areas or flammable materials.
Never pull the re-coil starter once the pressure washer
engine has started. Any damage caused will not be covered
by warranty.
Ensure the pressure washer has stopped before servicing,
or lubricating etc.
Do not attempt to modify the pressure washer, guards or the
supplied accessories in any way.
Do not touch the exhaust. This can become very hot during
operation and can cause serious burns.
Do not allow high pressure hose to touch the muffler.
Damage will occur and will not be covered by warranty.
Always check the pressure washer for damaged parts or
fuel leaks, ensure these are fixed before using it.
Never refuel while smoking or in the vicinity of
an open flame.
Always wear safety eye wear, ear and breathing protection
when operating or refuelling the pressure washer.
To avoid a fire if you spill fuel while refuelling, clean up
before starting the pressure washer.
Never operate or store the pressure washer on its side,
ALWAYS operate or store in an upright manner on firm,
solid ground.
Your pressure washer is factory set, NEVER attempt to
speed it up as this could endanger the user and damage the
pressure washer and/or attached appliances.
If the pressure washer makes an unfamiliar sound or
vibrates excessively, switch the pressure washer 'OFF'
immediately. Investigate the possible cause or consult your
authorised service agent.
Never use coolant in the pressure washer as damage may
occur.
Never transport the pressure washer with fuel in the tank.
ALWAYS empty the fuel tank.
Do not tamper or alter any parts as this may cause personal
injury or damage the pressure washer.
Never point gun/lance at people or animals.
Never hose or wet people or animals.
Never spray the pressure cleaner.
Never spray electrical connections, electrical outlets or
electrical appliances/fixtures.
Never operate the pressure cleaner without water, any
damage caused will not be covered by warranty.
Never use hot water.
Maximum water temperature is 40ºc.
Only use cold water with this pressure cleaner.
Bystanders or people watching must be at least 10m away
from operating the pressure cleaner.
Only use clean water with this pressure cleaner.
Never pump acids, alkaline, solvents or flammable liquids
through this pressure cleaner, any damage caused will not
be covered under warranty.
Never allow the high pressure hose to touch the muffler or
motor, as these hot surfaces will damage the hose. Damage
cause will be covered under warranty.
Do not keep motor running if not using the wand. Damaged
cause will not be covered under warranty.
Inlet water hose size must be at least 12mm diameter.
Inlet flow rate must be at least 10 L/min and mains pressure.
Damage may occur if pressure washer nozzle is held too
close to the cleaning surface. Damage caused will not be
covered under warranty.
Always trial the pressure washer cleaner and selected nozzle
on an inconspicuous part of the product to be cleaned.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents