Stanley PW6768 Instruction Manual page 17

TAKING A BREAK DURING USE
If taking a break of more than 2 minutes during use you must
turn the pressure cleaner off. See stopping below for how to
do this.
Damage will be caused if the pressure cleaner is left running
while the trigger is off no water coming out for more than 2
minutes. Damaged caused will not be covered under warranty.
WHEN FINISHED WITH DETERGENT
When finished with detergent, release trigger on wand. Remove
tube and filter from detergent bottle. Place tube and filter
around handle. Do not place on the ground as this will suck
dirt into pump. Any damage caused will not be covered under
warranty.
Squeeze trigger and continue cleaning with clean cold water.
STOPPING YOUR PRESSURE WASHER
1. Release trigger (stops water flow)
2. Slide variable speed control to low
3. Turn fuel tap off
4. Turn engine switch off
5. Turn water supply off
6. Squeeze trigger on wand to release water pressure and
some water
7. Disconnect garden hose from pump
8. Tidy high pressure hose and place on handle hold engage
wands safety lock for trigger
9. Allow machine to cool about 1 hour before wiping down and
storing.
CLEANING
NEVER use this pressure cleaner to clean itself. Damage
caused by cleaning the pressure washer with its own gun will
not be covered under warranty. Ensure pressure washer is cool
before cleaning, about 1 hour after use.
• Wipe down all surfaces with a soft clean cloth.
• Rinse all nozzles in a bucket of clean water.
• Place in holder to dry.
• Ensure fuel tap is off.
• Ensure engine switch is off.
• Ensure high pressure hose is left wound up and not kinked.
• Store in a suitable area away from children, infirm
persons animals.
• Store in a suitable area which will not freeze.
STORING
When storing for periods of more than 4 weeks please follow
these points to ensure no damage will occur to the pump or
motor. Any damage caused will not be covered under warranty.
Start motor and run for no more than 30 seconds. This cleans
the pump of excess water.
• Ensure the inlet water hose is not connected
• Ensure the high pressure hose is not connected to the pump
• Turn fuel tap on
• Turn choke lever to on (start)
• Insure speed lever is on high speed (rabbit)
• Turn engine switch to 'on'
• Pull recoil
• Turn choke to off (run)
• Allow motor to run no more than 30 seconds
• Slide speed lever to slow (turtle)
• Turn fuel tap off
• Turn engine switch off
• Drain fuel from tank
• Drain fuel from carburettor bowl
• Clean as per "cleaning"
17