Stanley PW6768 Instruction Manual page 16

SELECTING NOZZLE
Black
This nozzle is for low pressure and for use with detergent tube
and filter. Engine speed must be set on slow.
Red 0º
This nozzle is for high pressure and proves a single "pencil"
stream of water.
Yellow 15º
This nozzle is for high pressure and provides a wide 15º "fan"
of water.
Green 25º
This nozzle is for high pressure and provides a wide 25º "fan"
of water.
White 40º
This nozzle is for high pressure and provides the widest 40º
"fan" of water.
Connect / Disconnect Nozzles
Pic. 17
Connect
1. Pull done QC collar
2. Push nozzle into hole
3. Release QC collar
4. Click nozzle into position
Disconnect
1. Pull down QC collar
2. Lift nozzle out
3. Release QC collar
ENGINE SPEED LEVER
Pic. 18
This is adjusted ONLY from the handle. Never adjust from
anywhere else.
When using the black nozzle, low pressure, the engine speed
must be on low only.
When using any other nozzle, red, green, yellow, white, the
engine speed should be set on medium to high. The engine
speed is selected to lessen the force (pressure) coming out of
the nozzle. If the pressure is too high damage may occur and
this will not be covered under warranty.
PIC. 17
Spray nozzle tip
PIC. 18
16
Pull quick
connect collar
down
Spray wand