Stanley PW6768 Instruction Manual page 15

STARTING YOUR PRESSURE WASHER
Warning: Never start your pressure washer without water
running through the pump.
1. Check oil level.
2. Check and fill fuel.
3. Connect garden hose to cold water source.
4. Connect garden hose to garden connection on pump.
5. Turn cold water source on.
6. Release safety lock on trigger.
7. Squeeze trigger on wand. Hold down until all air is purged
and a steady stream of water is passing through, Pic 11.
8. Release trigger stopping flow.
9. If using detergent place tube and filter into detergent bottle.
10. Turn choke to start by sliding the choke lever to the left,
Pic 12.
11. Turn the fuel to run by sliding the fuel tap lever to the right,
Pic 13.
12. Ensure variable speed control is set to high, Pic 14.
Warning: Never use the lever on physical motor to adjust the
speed only use the variable speed control on the handle. Any
damage cause will not be covered by warranty.
13. Pull the recoil starter slowly until engaged, then pull briskly.
This step may need to be repeated until pressure washer
engine starts, this can take up to about 12 pulls, Pic 15.
Warning: Never pull the recoil once the engine has started. Any
damage caused will not be covered under warranty.
15. Once started turn choke to off (run), Pic 16.
PIC. 11
PIC. 12
CHOKE ON
PIC. 13
PIC. 14
To start set the variable
control speed to HIGH
PIC. 15
PIC. 16
15
FUEL ON
Starting Handle
CHOKE OFF
FUEL ON