Invacare Rea Comfort Assembly Instructions Manual page 39

2.
B
Tools: 10 mm fi xed spanner
3.
Tools: 2,5 mm Allen Key
Screwdriver
C
REA ASSIST
Fitting the cable
Lay the wheelchair on its backrest
2. Feed cable (A) through fi tting (B), as shown in the
E
diagram. Feed it through fi tting (C) and then feed
D
the end of the cable (D) into fi tting (E). Tighten
nuts (F) against one another.
F
C
F
B
A
3. Run the cable up to the right-hand push handle.
Use an Allen key to secure fi tting (A) in postion.
A
Use the two screws to secure the operating
handle (B) in position. Feed the cable into fi tting
(C) on the backrest rail, so as to hold the cable in
place.Tension the cable via the nuts next to the
piston, see diagram 1. There should be a minimal
amount of slack in the operating handle (B).
B
39