Invacare Rea Comfort Assembly Instructions Manual page 30

B
3.
A
G
Tools:
30
C
J
I H
F
K
I
E
D
5 mm Allen Key
6 mm Allen Key
13 mm fi xed spanner
3. Fitting the frontal electric motor
attachment for the tilt function and
backrest angle adjustment
Fit the screws (A) through the attachment (B),
place them against the tube according to the
picture, and fi t the plate (C) on the rear side.
Secure into place but do not tighten the screws.
Fit the motor (D) for the tilt function, beside
the attachment plate (E). Fit the spacer nut (F)
into the attachment plate and fi t the spacer (G)
between the attachment plate and the motor
attachment (B). Attach the front of the supporting
plate (H) using a screw (I) on each side of the
motor attachment/motor. Secure the back of
the supporting plate using the screw (J), washer
(K) and nut (L).
When you have fi tted the electric motor, you
must tighten the screws (A).
L
REA COMFORT