Advertisement
Removing the servo control board
* Prior to performing the following procedure, remove
the top cover and mechanism assembly.
1.Disconnect the card wire from connector CN201 and
CN202 on the servo control board respectively.
2.Disconnect the flexible wire from connector CN101
on the servo control board from pick-up.
ATTENTION
At this time, please extract the wire after short-circuited
of two places on the wire in part a with solder.
Please remove the solder two places of part a after
connecting the wire with CN101 when reassembling.
3.Two places in hook b are removed, the servo control
board is lifted, and it is removed.
Removing the rear panel (see Fig.5)
*Prior to performing the following procedure, remove
the top cover.
1.Remove the three screws C and nine screws E
attaching the rear panel on the back of the body.
Removing the front panel assembly
* Prior to performing the following procedure, remove
the top cover.
* There is no need to remove the mechanism assembly.
1.Remove the one screw F attaching the front panel
assembly on the bottom chassis.
2.Disconnect the wire from CN702 and CN703 on the
main board respectively.
3.Hook c and d are removed respectively, and the front
panel assembly is removed.
Removing the main board (see Fig.7)
* Prior to performing the following procedure, remove
the top cover, mechanism assembly, surround audio
board and rear panel.
1.Disconnect the wire from CN702 and CN703 on the
main board respectively.
2.Remove the four screws G attaching the main board
on the bottom chassis.
(see Fig.4)
(see Fig.6,7)
Front panel
assembly
CN703
Hook b
Fig.4
C
Rear panel
E
E
Fig.5
F
Hook c
Hook d
G
G
Fig.7
XV-S56BK/XV-S57SL
Hook b
Servo control
board
E
Hook d
Fig.6
G
CN702
G
1-7
Advertisement
