Advertisement
LED INDICATORS
The power indicator (4) has various
settings that show the charging status.
NOTE: If the power switch (11) is turned
off, the power indicator will not illuminate.
Pulsing Blue
Solid Blue
Solid Orange
All lights on
MANUALLY CHARGE (FIGURE A, B)
1. Plug the battery charger (23) into a
wall outlet.
2. Slide the jack plug (27) end of the charger
into the charging socket (12) of the
vacuum.
3. The power indicator (4) will blink,
meaning the vacuum is charging. The
power indicator will remain lit when the
vacuum is fully charged.
B
AUTOMATICALLY CHARGE
(FIGURE A, C, D)
1. Plug the battery charger (23) into a
wall outlet.
2. Slide the jack plug (27) end of the charger
into the charging dock's (21) charging
socket (28) as shown in Figure C. The
charging dock's LED screen (22) will
turn on.
3. Place the charging dock on the floor.
NOTE: Do not place anything under the
charging dock. It will prevent the vacuum
from automatically charging.
C
28
Charging—charged
enough to vacuum
Fully charged
Low battery—can not
vacuum
Error, robot stuck
27
27
4. Place the vacuum against the charging
dock so that the charging electrodes
(7) contact the two charging plates (29)
as shown in Figure D.
5. The power indicator (4) will blink and
the charging icon on the LED screen
(22) will scroll, meaning the vacuum
is charging. The power indicator
will remain lit when the vacuum is
fully charged.
NOTE: The vacuum will search for the
charging dock when it is low on battery.
However, if the room is too large or the
vacuum is obstructed from "seeing"
the dock, it may fail to find the dock to
automatically recharge. If this occurs,
place the vacuum at the charging dock as
described above.
D
Operation
SWITCHING ON AND OFF
In order for the vacuum to operate in any
cleaning mode, the power switch (11)
must first be switched on.
1. Press the side of the power switch
marked "ON".
2. Choose the mode and press the
corresponding button; spot (1), clean
(2), or max (3); on either the top of
the vacuum or the remote (24). The
vacuum will begin cleaning.
3. To stop the vacuum, press any button
on the vacuum or remote.
4. To turn the vacuum off completely,
press the side of the power switch
marked "OFF".
MODES
Spot mode - Press the spot button (1)
to select this mode. The vacuum will
clean in a spiral pattern for approximately
2-5 minutes. If the battery runs low, the
vacuum will automatically search for the
charging dock (21). This mode is ideal for
cleaning small areas, about 11 sqft (1m²).
Clean mode - Press the clean button
(2) to select this mode. The vacuum will
clean for 30 minutes depending on the
4
29
Hide quick links:
Advertisement
