Download Print this page

Power Switch - Black & Decker bdh5000 Instruction Manual

Hide thumbs

Advertisement

K
43
CLEANING THE BRUSHES
(FIGURE A, L‑N)
1. Turn the power switch (11) off.
2. Place the vacuum upside down on a
flat surface.
3. Press the release tab (44) on the brush
cover (16) and lift up to open.
L
4. Lift the main brush (14) and rubber
brush (15) out of the brush cover, then
pull them out away from the drive
shafts (45) in the brush well.
5. Remove all hair and debris using the
maintenance brush (26).
M
6. The brushes have a "D" drive and
must be installed correctly. Slide
the correct side onto the drive shaft
7. Close the brush cover. Ensure the
13
NOTE: Large debris such as hair and big
dust can be removed from the brushes by
using the comb end of the maintenance
brush (26).
REPLACING THE BATTERY
(FIGURE A, O)
1. Turn the power switch (11) off.
2. Place the vacuum upside down on a
3. With two hands, press in on the two
4. Lift the battery straight out of
5. To reinstall, slide the battery into place.
44
Accessories
Recommended accessories for use
with your appliance are available from
your local dealer or authorized service
center. If you need assistance regarding
accessories, please call: 1‑800‑544‑6986.
accessory not recommended for use with
this appliance could be hazardous.
REPLACING THE FILTER
The filter should be replaced every 6 to 9
months and whenever worn or damaged.
Replacement filters are available from
your BLACK+DECKER dealer.
7
(45) and lower the other end into the
support slot near the release tab.
cover has fully latched.
N
45
flat surface.
tabs (46) on the sides of the battery.
the vacuum.
Push down on the battery to ensure
both tabs have fully latched in place.
O
46
WARNING:
The use of any

Hide quick links:

Advertisement

loading

  Also See for Black & Decker bdh5000