Vcr To Tv Connection Using Rf Cable; Vcr To Tv Connection Using Audio/Video Cable - Philips VR 655 Instructions For Use Manual

G etting C onnected
G C

VCR to TV Connection Using RF Cable

1 1 Disconnect the antenna or cable from the TV.
1
2 2 Connect the antenna or cable to the ANT. IN terminal on the back of the VCR.
2
3 3 Connect the VCR to the TV using the RF coaxial cable.
3
4 4 Plug the AC power cords of the VCR and TV into the AC outlets.
4
Outdoor antenna
Cable
CAUTION
Do not plug the AC power cords
until all connections are completed.
To watch a picture from this VCR on the TV, select UHF E36 channel (video
channel of this VCR when shipped from the factory).
If you want to change video channel, see "Setting the Video Channel." ( P.5)

VCR to TV Connection Using AUDIO/VIDEO Cable

If your TV has audio/video connectors, complete the connection below to get better pictures and sounds when playing back
a tape. To watch a picture from this VCR on the TV, select the AV mode on the TV.
Note;
Even if you are using this AV
connection, you must also
complete the RF connection
above.
U p
U
Indoor antenna
Back of VCR
IN
AUDIO
VIDEO
RF OUT
Back of VCR
VR407/55
IN
AUDIO
VIDEO
To VIDEO/
AUDIO OUT
jacks
IN
AUDIO
VR607/55 VIDEO
ANT. IN
OUT
ANT.IN
R
L
RF OUT
Audio cable
ANT.IN
OUT
RF OUT
Video cable
Audio cable
ANT.IN
OUT
R
L
RF OUT
Video cable
4
Back of TV
VH F
UH F
RF coaxial cable
Note:
VR407/55 has single AUDIO IN/OUT jack.
Back of TV
To video and audio
input jacks