Setting The Video Channel; Menu Operations; Initial Setup - Philips VR 655 Instructions For Use Manual

S etting U p
S U

Setting the Video Channel

This VCR is designed to send picture and sound
signal on UHF channel E36 (between E28 to E60) to
the TV, through the RF coaxial cable.
1 Make sure the VCR is turned off and no cassette
is inserted.
2 Press STOP/EJECT
more than 5 seconds. All four indicators on the
display window will blink.
POWER CASS
5
3 Press PLAY or STOP
to select the TV system.
The indicators represent the TV system as de-
scribed in the table below.
TV
Country
System
West Europe, ASEAN
B/G
countries, New Zealand
China, Russia,
D/K
East Europe
Hong Kong, South
I
Africa, United Kingdom
4 Press OK/STATUS.
5 Turn on the TV, and tune it to UHF channel E36.
• If two vertical white bars appear clearly on the TV
screen, press OK/STATUS and go to step 6.
• If the two vertical white bars do not appear clearly, 5
press PLAY or STOP
set the video channel to any vacant channel be-
tween channel 28 to 60.
• The indicators tell channel position. The indicators
light and blink at different speed by the channel
position as shown in the table in the next column.The
POWER indicator blinks and the REC indicator
lights up regardless of the channel number.
6 Press OK/STATUS.
The CASS and TIMER indicator will turn off.
You will now enter the Language Setting mode
explained on the next column.
7 0
/
on the front panel for
REC TIMER
∞
on the remote control
Indicator
POWER CASS REC
blink blink blink
blink blink blink
off
blink
blink
∞
on the remote control to
Test signal
(two vertical white bars)
CHANNEL
60
51 - 59
50
41 - 49
40
37 - 39
36
31 - 35
30
29
28
To watch a picture from this VCR on the TV,
select the same channel you have selected as the
video channel on the TV.
Note:
If you use only external video input (AV) mode to watch
the picture from this VCR, you can turn off the video
∞
channel output. To turn off the video output channel, press
VCR CH
display window are off.
TIMER

Menu Operations

blink
Before operating the VCR, be familiar with the
off
menu operations first because most of the features
built into the VCR can be available only on the
off
menus.
1 Press MENU to display the main menu screen.
2 Press PLAY
feature on the menu, then press OK/STATUS.
3 When you select a feature, go to the section in
this manual and follow the instructions described
there.
2
To go back to the previous menu screen, press
3
REW
. To change the setting of a menu item,
. Press MENU to exit.
press FF
Initial Set Up
For the first time you turn on this VCR, some basic
settings must be done first before going on to
further operations.
1
Select the Language
1 Press POWER.
The language selection screen
appears.
2 Press PLAY
to select either "ENGLISH",
or " " (Chinese).
3 Press OK/STATUS.
5
TIMER
CASS
indicator
indicator
light
blink
light
blink
light
blink
light
light
blink
light
blink
light
until CASS and TIMER indicators on the
5 ∞
or STOP
to select a desired
5 ∞
or STOP
Blinking Speed
fast
slow
slow
fast
ENGLISH
SELECT: CONFIRM: OK
END: MENU