Speed 1-8 (Schedule A Time To Run The Pump) - Pentair INTELLIFLO WHISPERFLOVSD Installation Manual

19

Speed 1-8 (Schedule a Time to Run the Pump)

By setting a start time and a stop time, Speeds 1-8 can be programmed to run a certain speed at a certain
time of day. To run a scheduled pump speed, press the Start button (LED on). The LCD screen will
display "Running Schedules" when it is ready to run a scheduled speed. If the start button is pressed
during a scheduled speed time, the screen will read Running Speed X and will run speed X. (If priming
is enabled, it will prime first at the maximum RPM setting of the pump before running speed X.)
Note: The IntelliFlo
pressed (LED on) to place the pump in the "Running Schedule" mode.
To set a schedule to run the pump:
1. Check that the green power LED is on.
2. Press the Menu button. "Settings" is displayed.
3. Use the Up or Down arrow button to scroll to "Speed 1-8".
4. Press the Select button. "Speed 1" is displayed.
5. Use the Up or Down arrow button to choose the speed you wish to program.
6. Press the Select button. Select Manual,
or "Schedule" for speed 5-8
Speeds 1-4 default setting is MANUAL. To create a schedule for speed 1-4 Press Select to
highlight manual.
Speeds 5-8 default setting is DISABLED. To create a schedule for speed 5-8, Press Select to
highlight Disabled.
7. Use the Up or Down arrow button to scroll to "Schedule".
8. Press the Enter button.
9. Press the Down arrow button. Set speed will be displayed.
10. Press the Select button to change the speed. The first digit
11. Use the Up or Down arrow button to change the speed.
12. Press the Enter button to save the setting.
13. Press the Down arrow button. "Set Start Time" is displayed.
14. Press the Select button to change the start time.
15. Use the Left arrow button to move the cursor to the hour column if desired.
16. Press the Enter button to save the setting.
17. Press Down arrow. "Set Stop Time" is displayed
18. Press the Select button to change the stop time.
19. Press the Enter button to save the setting.
20. Press the Start/Stop button. The LED above the button will light up and the pump will start
if within a scheduled time or "Running Schedule" is displayed.
When the pump is running a scheduled speed or a duration speed (egg timer) the countdown time
(T 00:01) showing the hours and minutes is displayed on the screen.
Note: Speeds 5-8 can be programmed to operate in Schedule mode only. The IntelliFlo
Variable Speed pump can run eight (8) different speeds at eight (8) programmed start and stop
times per day.
Note: When two speeds are scheduled during the same run time the pump will run the higher
RPM Speed regardless of Speed # in use.
pump will not run the scheduled speeds until the Start/Stop button is
®
is displayed.
Schedule, or Egg Timer for speeds 1-4. "Disabled"
will highlight (ones digit).
The cursor will highlight the minute column.
®