Novation Circuit Mono Station User Manual page 16

English
Synth controls:
Apart from the MASTER section, the upper half of Circuit Mono Station's control surface has
the controls for the mono synth engine.
OSCILLATORS section:
Range – steps through the base pitch ranges of the oscillator selected by Osc 1 or
16
Osc 2 in octaves. For standard concert pitch (A3 = 440 Hz), set to 8'.
5
Waveform – steps through the range of available oscillator waveforms – sine, triangular,
17
sawtooth and pulse.
Coarse – adjusts the pitch of the selected oscillator over a range of ±1 octave.
18
Fine – adjusts the oscillator pitch over a range of ±100 cents (±1 semitone).
19
LFO section:
Rate – adjusts the frequency of the LFO.
20
Wave – this button steps through the available LFO waveforms: triangle, sawtooth,
21
square, sample and hold. The associated LED gives a visual indication of the LFO speed and
waveform.
Sync – press to synchronise the LFO rate to the current tempo clock (internal or external).
22
35 different sync rate divisions are available: use the Rate control
MIXER section:
Osc 1 – controls level of Oscillator 1's waveform.
23
Osc 2 – controls level of Oscillator 2's waveform.
24
Sub – controls level of the Sub Oscillator signal.
25
Noise – controls the level of white noise added to the sound.
26
Audio In – level control of the signal applied at the rear panel AUDIO IN connector
27
Ring 1*2 – sets the output level of the Ring Modulator circuit: the inputs to the Ring
28
Modulator are Osc 1 and Osc 2.
ENVELOPE section:
A set of four faders adjusting the usual ADSR Envelope parameters (Attack, Decay,
29
Sustain and Release).
to select one.
20
.
2
16