Advertisement
5. Pulse Output Verifi cation
Using the Dresser MeterWare software, the Corrector pulse output allocation is confi gured
in the Volume Confi guration screen, as shown in Figure 6. Refer to this screen to verify
proper confi guration. Refer to the MeterWare Manual for complete operating instructions.
Figure 6 - Volume Confi guration screen in Dresser MeterWare software
To ensure pulse outputs are properly wired, the Dresser MeterWare software
has a test function available on the Advanced screen, as shown in Figure 7.
Figure 7 - Advanced screen in Dresser MeterWare software
After clicking "Test Pulse Outputs," a screen appears as shown in Figure 8.
Click "Yes" to proceed with the pulse output test. For further information,
refer to the Dresser MeterWare Manual.
Figure 8- Send test Pulses screen in Dresser MeterWare software
GE Oil & Gas
16240 Port Northwest Drive, Suite 100
Houston, TX 77041
P: +1 832.590.2303 Inside US P: 800.521.1114
F: +1 832.590.2494 Inside US F: 800.335.5224
Visit us online at:
www.ge.com/energy
2012 General Electric Company
All Rights Reserved
* Denotes a trademark of General Electric
Company
GEA19694 IS:B3E
2.12
Advertisement
