Fluke 1736 User Manual page 43

To select between Load Study and Energy Study:
1. Go to Meter > Change Configuration. This
Configuration screen contains the measurement
configuration parameters such as Topology, current
range, voltage, and current ratios.
2. See page 20 for more information about measurement
configuration.
3. After you review these parameters, push the Start
Logging touch target to start recording.
4. If you want to modify the parameters, push the Edit
Setup touch target. The settings are kept during a
power cycle. This allows you to configure the logging
session in the office when more convenient and avoid
this time-consuming task in the field.
Name
The Logger auto-generates a file name with the format
ES.xxx or LS.xxx.
ES ... Energy Study
LS ... Load Study
xxx ... incremental file number
The counter resets when the Logger is set to factory
defaults. See page 47 for details. You can also choose a
custom file name with up to 31 characters.
Duration and Recording Start/Stop Date and Time
You can set the duration of the measurement from a list.
No end configures the maximum possible duration based
on the available memory.
For a duration not shown in the list, select Custom to
enter the duration in number of hours or days.
The logging session stops automatically when the time
duration has elapsed. Also, you can manually stop the
logging session at any time.
A logging session starts to record immediately when you
push the Start Logging touch target. You can configure a
scheduled recording. It is either configured by the duration
and the start date and time or by the start date and time
and stop date and time.
This is a convenient method for how to set up the Logger
to measure a full week profile starting on Monday 0:00 and
ending on Sunday 24:00.
Even when a start date and time has been
configured, you must push the Start Logging
button.
Power Logger
Function Selection Buttons
Note
33