Replacing The Power Fuse; How To Eject A Disc In The Case Of Emergency - Sony CDP-D12 Service Manual

1-4-2. Replacing the Power Fuse

w
Components marked ! are critical to safe operation.
Therefore, specified parts should be used in the case of
replacement.
c
Before replacing the power fuse, make sure that the power
cord of the unit is disconnected from the AC outlet to
prevent the electric shock.
n
If a trouble occurs on the unit by flowing the over-current,
the fuse will blow.
The fuse should be replaced with following parts after
removing the foreign matter.
Ref No. Board name
F1 POWER board
1. Remove the cover.
(Refer to 1-3. "Removing the Cabinet".)
2. Remove the fuse from the fuse holder on the POWER
board.
3. Install the new fuse by reversing the steps of removal.
Fuse
POWER bpard
CDP-D12
Sony part No.
! 1-533-449-11 (for J/U)
! 1-532-215-00 (for CE/CN)
Fuse holders
1-5. How to Eject a Disc in the Case of
Emergency
1. Turn off the power and disconnect the power cord
from the AC outlet.
2. Remove the cover and the front panel.
(Refer to 1-3. "Removing the Cabinet".)
3. Remove the chassis (SUB) by performing steps 2 and
3 of Section 1-4-1 item 1. "Removing and Installing
the CD mechanism deck assembly (MG-398SC-121)".
4. Remove the chassis (T388) assembly by performing
step 3 of Section 1-4-1 item 2. "Chassis (T388)
Assembly".
5. Raise the chucking arm assembly in the direction of
arrow A, and remove the disc in the direction of arrow
B.
B
Disc
Chucking arm assembly
A
1-11