Sony CDP-D12 Service Manual page 15

3. SENSOR board
1. Remove the CD mechanism deck assembly.
(Refer to item 1 of Section 1-4-1.)
2. Remove the chassis (T388) assembly.
(Refer to item 2 of Section 1-4-1.)
3. Push the two claws of the guide (DISC M) in the
direction of arrow A and remove the guide (DISC M)
in the direction arrow B.
4. Remove the screw and remove the SENSOR board.
5. Install the new SENSOR board by reversing the steps
of removal.
Claws
B
A
Guide (DISC M)
Chassis (T388) assembly
CDP-D12
4. SERVO board
1. Remove the CD mechanism deck assembly.
2. Remove soldering of the LO motor assembly at the
3. Remove soldering of the SERVO board at the two
4. Disconnect the two cables from the connectors (CN2,
5. Remove the three screws and remove the SERVO
6. Install the new SERVO board by reversing the steps of
A
Special screw
SENSOR board
LO motor assembly
(Refer to item 1 of Section 1-4-1.)
n
If the chassis (T388) assembly is still installed when
removing the SERVO board, remove soldering of the
chassis (T388) assembly.
(Refer to item 2 of Section 1-4-1.)
two positions.
positions.
CN3) on the SERVO board.
board.
removal.
Solders
Red
White
CN3
Yellow
SERVO board
Special screws
CN2
Solders
Black
1-7