Table Of Contents - Sony PEGA-CC5 Service Manual

PEGA-CC5

TABLE OF CONTENTS

1. SERVICING NOTES
2. GENERAL
Location of Controls ....................................................... 5
3. DISASSEMBLY
3-1. Disassembly Flow ........................................................... 29
3-2. Front/Rear Panel Assy ..................................................... 29
3-3. MAIN Board ................................................................... 29
3-4. CN Board ......................................................................... 29
4. DIAGRAMS
4-1. Block Diagram - AUDIO Section - ............................... 30
4-2. Block Diagram - MAIN Section - ................................. 31
4-3. Note for Printed Wiring Boards and
Schematic Diagrams ....................................................... 32
4-4. Schematic Diagram - MAIN Board (1/5) - ................... 33
4-5. Schematic Diagram - MAIN Board (2/5) - ................... 34
4-6. Schematic Diagram - MAIN Board (3/5) - ................... 35
4-7. Schematic Diagram - MAIN Board (4/5) - ................... 36
4-8. Schematic Diagram - MAIN Board (5/5) - ................... 37
4-9. Printed Wiring Boards
- MAIN Board (Component Side) - .............................. 38
4-10. Printed Wiring Board
- MAIN Board (Conductor Side) - ................................ 39
4-11. Printed Wiring Board - CN Board - .............................. 40
4-12. Schematic Diagram - CN Board - ................................. 41
4-13. IC Pin Function Description ........................................... 44
5. EXPLODED VIEW
5-1. General Section ............................................................... 53
6. ELECTRICAL PARTS LIST
2
............................................... 3
............................... 54
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 ˚C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 ˚C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges oc-
cur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.