AEG 10660GN-MN User Manual page 20

20
Oven burner (fig. 23)
The burner is installed on the oven base
and is covered by the bottom plate which
must always remain in that position during
oven operation,
To adjust the primary air, light the
burner and, watching the flame, slacken
screw and adjust sleeve
1
the openings indicated in the table
5
in the "TECHNICAL INFORMATION"
section. Lock screw
adjustments have been made.
Fig. 23
Grill burner (fig. 24)
To adjust the primary air, light the
burner and, watching the flame, slacken
screw and adjust sleeve
1
the openings indicated in the table
5
in the "TECHNICAL INFORMATION"
section. Lock screw
adjustments have been made.
2
3
to obtain
2
in place once the
1
3
1
2
5
4
1
to obtain
2
in place once the
1
1
4
2
1
5
Conversions
Our burners can be adapted to different
types of gas by simply installing the
injectors suitable for the gas you want to
use. To help the installer, the table in the
"TECHNICAL INFORMATION" section
gives the burner nominal heat input,
injector diameter and operating pressure
of the different gas types.
Comply with the following instructions:
Injector replacement - Hob burners.
To change the injectors on the hob,
remove the burner cup and head and with
a 7 mm Ø socket spanner replace them
(fig. 25).
Remove oven base. Remove screw
which will release burner and give access
to the injector
4
and replace it. Replace burner and replace
screw
Injector replacement - Grill burner.
Remove screw
burner and give access to the injector
2
(fig. 24).Unscrew injector
Replace burner and replace screw
it will be necessary to proceed with
burner adjustment as explained in the
previous paragraphs. The technician
must replace any seals after the
adjustments have been made.
Fig. 25
4
Fig. 24
(fig. 23). Unscrew injector
3
.
4
4 which will release
3
4
and replace it.
.
4