Advertisement
TECHNICAL GUIDE
STEP TWENTY-EIGHT
With the drum cover spring as shown on the end cap,
install the end cap. Lift up the tail of the spring to fit onto
the hopper.
STEP TWENTY-NINE
Lift up the drum cover sprint tail to fit as shown
on the drum cover. Install the screw into the
cover.
STEP THIRTY
Replace the chip by slicing off the melted chip rails.
If the chip seems loose upon installation, you can
place small dabs of hot glue on the corners to hold
it in place.
Repetitive defect chart
OPC drum
Upper fuser film
Lower pressure roller
Transfer roller
Magnetic roller
PCR
©2015 Recycler Publishing & Events Ltd
By Mike Josiah and the Technical Staff at Uninet
75mm
57mm
56mm
39mm
34mm
27mm
THE RECYCLER - TECHNICAL GUIDE
PAGE 9
Advertisement
