Advertisement
TECHNICAL GUIDE
STEP TWENTY
There are two screws holding the doctor blade in place.
To install a seal, remove the seal port plug, and install
The left screw is a normal thread screw; the right side
the seal. Bring the tail out through the seal port hole.
uses a left hand thread screw. Be careful not to mix them
Install the plug.
up
STEP TWENTY-ONE
Install the left side end cap and screw. Make sure the
small contact piece is installed correctly on the end cap.
STEP TWENTY-TWO
Install the doctor blade and two screws.
STEP TWENTY-THREE
Install the magnetic roller black bushing side first. Turn the
roller until the keyed end locks in place.
©2015 Recycler Publishing & Events Ltd
By Mike Josiah and the Technical Staff at Uninet
THE RECYCLER - TECHNICAL GUIDE
PAGE 7
Advertisement
