Related Manuals for Kramer 810
Summary of Contents for Kramer 810
- Page 1 K R A ME R E LE CT R O N IC S L TD . USER MANUAL MODEL: Color Bar/Audio Generator P/N: 2900-006003 Rev 2...
-
Page 3: Table Of Contents
Defining the 810 Color Bar/Audio Generator Connecting the 810 Adjusting the Audio Level Technical Specifications Figures Figure 1: 810 Color Bar/Audio Generator Figure 2: Connecting the 810 Color Bar/Audio Generator Figure 3: Underside of the 810 Color Bar/Audio Generator 810 – Contents... -
Page 4: Introduction
Scan Converters and Scalers; GROUP 8: Cables and Connectors; GROUP 9: Room Connectivity; GROUP 10: Accessories and Rack Adapters and GROUP 11: Sierra Products. Congratulations on purchasing your Kramer 810 Color Bar/Audio Generator, which is ideal for: Testing and aligning video equipment, including monitors, recorders and... -
Page 5: Getting Started
Avoid interference from neighboring electrical appliances that may adversely influence signal quality Position your Kramer 810 away from moisture, excessive sunlight and dust This equipment is to be used only inside a building. It may only be connected to other equipment that is installed inside a building. -
Page 6: Safety Instructions
To comply with the WEEE Directive, Kramer Electronics has made arrangements with the European Advanced Recycling Network (EARN) and will cover any costs of treatment, recycling and recovery of waste Kramer Electronics branded equipment on arrival at the EARN facility. 810 - Getting Started... -
Page 7: Overview
Overview The 810 is a high−performance composite video and s−Video (Y/C) color bar and 1kHz audio tone generator. It outputs two composite video and one s−Video color bar signal in either NTSC or PAL, and a 1kHz audio tone simultaneously. -
Page 8: Connecting The 810
Connecting the 810 Always switch off the power to each device before connecting it to your 810. After connecting your 810, connect its power and then switch on the power to each device. To connect the 810 as illustrated in the example in Figure 1. -
Page 9: Adjusting The Audio Level
Adjusting the Audio Level The audio level of the 810 is pre-set at the factory at 4dBm. However, you can adjust the audio level on your 810 Color Bar/Audio Generator, if you wish. To adjust the audio level: 1. Insert a screwdriver into the small hole on the underneath of the 810 Color Bar/Audio Generator, enabling access to the trimmer. -
Page 10: Technical Specifications
-40° to +70°C (-40° to 158°F) HUMIDITY: 10% to 90%, RHL non-condensing DIMENSIONS: 12 cm x 7.5 cm x 2.5 cm (4.7 inch x 2.95 inch 0.98 inch, W, D, H) WEIGHT: 0.3 kg (0.67 lbs.) approx. INCLUDED ACCESSORIES: Power supply 810 - Technical Specifications... - Page 12 For the latest information on our products and a list of Kramer distributors, visit our Web site where updates to this user manual may be found. SAFETY WARNING Disconnect the unit from the power supply before opening and servicing P/N:...
Need help?
Do you have a question about the 810 and is the answer not in the manual?
Questions and answers