Cisco TelePresence MX700 Installation Manual page 14

Installation guide for Cisco TelePresence MX700 Dual camera - Floor stand
9
Fasten right monitor to floor stand and connect power cable
Connect power cable
2
Connect the loose end of
the power cable from step
10 to the close-by socket at
the rear of the right monitor.
The socket must be reached
from below.
Make sure that the power
switch next to the socket is
in its ON position.
78-100277-02A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
4 × M6x90,
countersunk
4 × M6x35,
countersunk
Enter four screws from
1
front and four screws from
underneath. Then, tighten
all screws.
Page 14