Table of Contents
Advertisement
rc1364101 (1)
4/30/03
Programming the Universal Remote Control (cont'd)
Automatic Search
To automatically program your remote control to operate your TV, VCR, or DVD
Player, follow the steps below. For a VCR or DVD Player, follow the same steps but
press the VCR or DVD button at step 1.
1. Turn on your TV. Stand close to your TV (5 to 10 feet) and point your remote
control towards the remote sensor on your TV. Press TV button until LED
lights. Press and hold the number 1 and the number 3 buttons simultaneously for
3 seconds. The LED will blink twice and remain on.
2. Press the POWER button. The LED will turn off. Note: If the Power button is not
pressed within one minute, the remote will return to the previously programmed
code. The automatic search will begin after the Power button has been released.
3. Each time a code is transmitted, the LED will blink. This process could take sev-
eral minutes.
4. When the correct code is found, the TV should turn off. Immediately press the
POWER button. The LED will blink twice, then turn off. If all codes have been tried
and the TV has not turned on or off the LED will stay on briefly, then turn off.
Note: To stop the search process at any time, press any button other than the
POWER button. The LED will give a long blink and turn off. There is no guarantee
that the remote control will work with your TV, VCR, or DVD player.
Helpful Hint
•
If the 3-digit code is not
entered within 60 seconds,
the LED will turn off and
the remote control will
return to the previously
programmed code.
•
If the batteries are left out of
the remote for more than
two minutes, you may have
to reprogram the remote
control.
3:41 PM
Page 12
12
Advertisement
Table of Contents
