Getting Started; Inserting The Batteries; Setting Up The Universal Remote Control; Control - Philips SRP2003/27 User Manual

2 Getting started
2.1 Inserting the batteries
•
Insert 2 AAA type
batteries, noting the
+ and -
configuration in the
battery
compartment.
Note
When replacing the batteries, all user settings
will be retained in the remote control
memory for 5 minutes.
2.2 S etting up the universal remote

control

The example below instructs you how to set up
your universal remote control for your TV.
You can repeat the same steps for other devices
(DVD player/recorder and Cable/Satellite box)
which you want to operate, using the SRP2003.
The remote control can be set up to operate
any 3 of the following devices:
Device name Description
TV Traditional TV, flat screen
TV and projection TV, TV
part of TV / VCR, TV / VCR
/ DVD and TV / DVD
combos
DVD DVD player / recorder
(DVDR), DVD / Hard
Disk Drive combination
(DVDR-HDD), Blu-Ray
player, High Definition
DVD player (HD-DVD),
DVD part of TV / DVD, TV
/ VCR / DVD and VCR /
DVD combos
4 EN
CBL/SAT Cable box, satellite
receiver, Internet Protocol
TV (IPTV), Free To Air TV,
High Definition Television
decoder (HDTV) and Tivo
Example: s etting up the universal remote
control to operate your TV:
1
S witch ON the TV manually or use the
original remote control for this. Tune to
channel 1.
2
Press and hold the
device selection
button for 5 seconds
until the red Setup
light remains lit .
The remote control
is now in setup mode.
3
Look up the 4-digit
code for your brand
in the brand list at
the back of this user
manual.
A 4-digit code is
shown for each brand.
Use the digit
buttons to enter the
code for your brand.
• If the red Setup
light turns off,
an invalid code
was entered. In this case, try again.
4
Aim the remote
control at the TV.
Press and hold the
button. Release
it immediately as
soon the TV
switches off.
• This step normally takes between
5 and 60 seconds. In extreme
circumstances this step can take up to
15 minutes.
5 sec.
5-60 SEC.
5 - 60 sec.
EN 5