Fireback - Avalon Freestanding Stove Owner's Manual

Optional Equipment
4 0
4 Make sure all of the wiring is placed away from the blower impeller and the bottom of the burner. Use
lock ties, if necessary, to ensure no wires are damaged.
5 Open the control cover following the directions below. Remove the button plug and install the
rheostat.
Loosen the two screws holding the control
box in place. This allows access to the
a
back of the control box.
Phillips
Screwdriver
6 Plug the blower in. Let the heater achieve operating temperature and test blower operation.

Fireback

(Part # 99600220)
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
1 Before installing, remove the face, glass, and logs. Install the firebacks following the directions below.
Side Fireback
c
Place the side firebacks on
the ledges at each side of
the firebox.
Travis Industries
Control Box
Back of
Stove
Remove the button plug
b
from the control box.
Fireback Clip
(for qualified installers only)
Attach the rheostat wires to the two
quick connects inside the control
c
box (orientation does not matter).
Rheostat
Remove the screws at the
a
top of the firebox walls.
5/16" Nutdriver
Secure the firebacks with the
d
included clips and screws
(removed in step "a").
9 3 5 0 8 1 1 5
NOTE: make sure the
fiberglass heat shield is in
place when re-attaching the
control box.
e
Attach the rheostat to
the control panel with
the included nut and
star washer.
1/2"
Wrench
Attach
the knob.
NOTE: this tab fits into the
hole on the mounting bracket.
b
Place the rear fireback (it
rests on the two ledges on
each side of the firebox).
The side firebacks keep the
rear fireback from tilting
forward.
Rear
Fireback
4 0 5 0 1 1 3