Guitar Tuner; Declaration Of Conformity; Factory Reset - Marshall Amplification CODE25 Owner's Manual

GUITAR TUNER

Pressing the PRE FX and AMP Section Switches (#14 & #15 in this manual) together
accesses the guitar TUNER:
• Pluck a string and the note you are playing will display.
• Tune the string until the name of the note you wish to tune to appears on the screen.
• Arrows to the left of the vertical line means the note is flat; arrows to the right of the
vertical line means the note is sharp.
• When the arrows disappear, that string is tuned to the displayed note.
• Press EXIT/STORE to exit the Tuner.

FACTORY RESET

Performing a factory reset will return CODE's Presets back to when it was new.
Before performing a factory reset, be sure that you want to overwrite all of your personal
!
Presets.
To perform a factory reset:
• Power OFF the amplifier using the ON/OFF switch (#13 in this manual).
• Whilst holding down the AMP Section Switch, turn the power ON.
• The screen will display a notification that the amplifier is about to be returned to its
factory settings.
• If you are sure that you want to perform a factory reset, press and hold the EXIT/STORE
switch to confirm.
• If you do not want to restore the factory presets, pressing any other switch will cancel the
factory reset operation and boot the amplifier as normal.
ENGLISH
A: >>|<<
A: >>|<< A: >>|<< A: >>|<< A: >>|<<

DECLARATION OF CONFORMITY

Marshall Amplification Plc,
Denbigh Road,
Bletchley,
Manufacturer: Milton Keynes,
Bucks,
United Kingdom
MK1 1DQ
Kind of equipment: Audio Equipment
Type designation: CODE25, CODE50
We, Marshall Amplification Plc, declare under our sole responsibility that the above listed products complies with the following
Directives:
1. EMC Directive 2014/30/EU;
2. Low Voltage Directive (LVD) 2014/35/EU;
3. R&TTE Directive 1999/5/EC.
The following harmonised standards have been applied:
• EN 55013:2013
• EN 55020:2007+A11:2011
1. EMC
• EN 61000-3-2:2014
• EN 61000-3-3:2013
2. LVD • EN 60065:2014
Health &
• EN 62479:2010
Safety
• EN 60065:2002 + A1:2006 + A11:2008 + A2:2010 +A12:2011
(Article 3(1)(a))
3. R&TTE
EMC • ETSI EN 301 489-1 V1.9.2:2011
(Article 3(1)(b)) • ETSI EN 301 489-17 V2.2.1:2012
Spectrum
• ETSI EN 300 328 V1.9.1:2015
(Article 3(2))
Signature: Name: B. Moon
Name of the responsible party: Jam Industries USA, LLC
Address of the responsible party: 1649 Barclay Blvd, Buffalo Grove, IL 60089, United States of America.
Telephone number of the
800-877-6863
responsible party:
Name of equipment: MD116D Guitar Amplifiers
Model No.: CODE25, CODE50
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
ENGLISH
Date: 2nd May 2016
16