For Future Reference - Be Cool camper Instructions Manual

IMPORTANT: KEEP THESE INSTRUCTIONS
GB

FOR FUTURE REFERENCE.

WARNINGS:
COMPLIES WITH EUROPEAN SAFETY REGULATIONS EN716-1/2: 2008 (+A1:2013)
• The cot can only be used when all the locks of the folding mechanism are correctly adjus-
ted.
• Do not leave any object in the cot nor place the cot near any other product which the child
could push his feet against, or which could present a risk of asphyxiation or strangulation,
for example, strings, curtain or blind cords, etc.
• The thickness of the mattress must be chosen so that the internal height is at least 500
mm
with the base in the lowest position, and at least 200 mm when in the highest position.
• Make sure that all assembly devices are properly adjusted.
• Never leave this product next to a flame or sources of intense heat, such as electric or gas
fires.
• Do not use string to tie or suspend toys to the cots.
• The camping cot may be used by children up to 14 kg. or 86 cm. in height.
• To avoid fire risk, never use or keep the cot next to sources of heat, such as electric radia-
tors, gas fires, etc.
• The child must be watched at any time.
• The screws located in the external part of the cot must always be tightened. This will ensu-
re
that the child cannot hurt itself or get hooked up by its clothes or accessories: cords,
comforter chain links, etc., which could lead to a danger of strangulation.
• This cot is not designed for commercial use or for storing products.
• Do not use the cot if any of the parts are broken, in bad condition or missing, and only use
replacement parts that have been approved by the manufacturer.
• Do not use more than one mattress in the cot.
• The lowest position is the safest position; it is advisable to use this position once the child
can sit up by himself.
• The maximum mattress thickness that can be used with the cot is indicated with an
arrowinside the cot.
• The length and width should be such that the gap between the mattress and the sides and
the head and footboard is not greater than 30mm.
• Make sure that the assembly mechanisms are always appropriately adjusted and they
should be regularly checked and adjusted if necessary.
• The cot should not be used if the child is able to get out of the cot by himself.
• Fit the protective covering correctly over the clips when the booster base is not installed.
• The length and width of the mattress should be at least 118x58 cm.
3