InMotion SCV H1 Instruction Manual page 20

6. Product Storage and Maintenance
6.1 Use of battery
1. Charging: Check charge interface and ensure the charge interface is dry. At first, plug the output terminal of charger into the
charge interface of drift car and then plug the plug of charger into 220V AC power source. Please do not plug the charger into power
at first to avoid the problem of no charging. During charging process, the indicator lamp of charger is red. After completion of
charging process, the indicator lamp of charger is green, at this time, you shall disconnect the power of charger before unplugging
charger. It takes about one hour from zero power till full power charging. For your use safety, it is suggested that you shall stop using
the car when hearing warning or seeing the red indicator lamp of power, and charge the battery as soon as possible. While extending
the service life of battery, it can also ensure the driving safety and avoid the safety risk caused by dead battery.
Note: Original charger can be used as the charging device replacing battery, but it shall be used together with converter provided by
original factory. Please do not use accessory not provided by original factory to avoid any safety problem.
2. Battery life: In case the battery has not been used for a long time, it is suggested to change the battery for once in each month to
keep the energy of battery.
6.2 Battery storage and maintenance Storage
It is suitable to keep the storage temperature at -10º-30ºC. Higher or lower temperature might affect the normal use of lithium battery.
It is suggested to store the car and battery at ventilated, dry and cold place.
20