Actions; Load Balancing - Opticon ESL Server Manual

Actions

6.4.1.
 Reset
 Show default image
 Refresh image
 Resend image
 Request settings
 Unlink
 Find best base station Search for a base station with a better link quality
 Kick from base station Search for another base station
 Move to base station
 Set LAN-Id
 Clear LAN-Id
 Deactivate
 Factory default
 Radio test mode

Load balancing

6.4.2.
ESL server 1.45 and higher has to possibility to automatically and manually re-balance the ESLs over
all available base stations. Enabling this option on a daily basis improved the average link quality of the
ESLs, because all ESLs with poor link quality will check if there's a better base station available.
Especially after a new base station was added or a base station has been temporarily offline, it can be
beneficial to execute load balancing manually.
Resets the firmware of the ESL, causing it to reassociate with the
same base station
Make the ESL show the default image with its MAC address (if the
ESL is linked, the default image is shown for 15 minutes after which
the product image is send again)
Refreshes the current image on the ESL
Resends the current image to the ESL
Force the ESL to send its current settings
Unlinks the ESL from the link database
Move ESL to the specified base station
Sets the LAN-Id (see chapter 5.3)
Clears the LAN-Id (see chapter 5.3)
De-activate the ESL for transport or storage
Resets the firmware of the ESL to default
Used for certification only (disabled by default)
31
Opticon ESL
ESL Server manual
v1.0.62.2