Advertisement
Quick Links
EBS-40
Quick Start Guide
Package Contents
• EBS-40 Base Station
• Antenna (2)
• Quick Start Guide
EBS-40 Quick Setup
1. Connect power (power supply sold
separately).
2. Plug your network cable into Ethernet
Port 1. The other port can be used to
daisy chain additional EBS-40 units.
3. DHCP is enabled by default.
4. If no DHCP server is available then the
EBS-40 will use the default IP address
and subnet which can be found on the
label on the bottom.
5. Network settings can be changed via
the built-in web page, accessable via the
assigned (or default) IP address.
www.opticon.com
Reset Switch
DC Power
Ethernet Port 1
Ethernet Port 2
Advertisement
Related Manuals for Opticon EBS-40
Summary of Contents for Opticon EBS-40
- Page 1 EBS-40 units. 3. DHCP is enabled by default. 4. If no DHCP server is available then the EBS-40 will use the default IP address and subnet which can be found on the Reset Switch Ethernet Port 1 label on the bottom.
- Page 2 Two large LEDs sit on the top surface of the deliberately subject it to any of the following. EBS-40. The power LED is a steady red while the Use common sense when handling this product. unit has power. The data LED will blink green to...