Set-up
9
Set-up
9
Inserting the needle
.01
PFAFF 1245
O Bring the needle bar to the top posi-
O Loosen the screw 1 and insert the
O Tighten the screw 1.
28
Observe and comply with all regulations and instructions in this instruction
manual. Pay particular attention to all safety regulations!
All set-up work may only be carried out by appropriately instructed personnel.
Disconnect the machine from the electricity mains for all set-up work by operat-
ing the main switch or by removing the mains plug!
1
Fig. 9 - 01
Switch off the machine!
Risk of injury due to accidental machine start-up!
Only use needles of the system intended for the
machine, see Chapter 3 Technical Data!
tion.
needle 2 until you feel it stop. The
long groove must point to the left.
2
Fig. 9 - 02
PFAFF 1246
O Bring the needle bar to the top position.
O Loosen the screws 1.
O Loosen the screws 1 and insert the
needles 2 until you feel them stop. The
long groove of the left needle must point
to the right and that of the right needle
must point to the left.
O Tighten the screws 1.
1
2